Our process
A clear process built around preparation, finish and lasting results.
Good wrapping is not just about applying a new finish. The result depends on careful assessment, proper preparation and knowing where things usually fail over time.
How we work
The right prep work is what separates a quick cover-up from a quality result.
Assessment: we look at the condition of surfaces, edges, high-wear areas and overall suitability.
Preparation: surfaces are cleaned, repaired where possible and properly prepared for adhesion.
Application: finishes are applied neatly with attention to detail around corners, handles, edges and joins.
Final review: we check the finish, consistency and overall presentation before sign-off.
How we eliminate failure
Neatly wrapped 1cm onto the back of every door.
We complete every wrap neatly just 1cm onto the back of the door, creating a clean, consistent finish. This serves three important purposes.
Moisture protection
By wrapping onto the back, no moisture can enter underneath the vinyl.
Longevity
Sealing the edge onto the back helps the material stay in place over time.
Away from high-traffic areas
Moving the edge to the back keeps it away from daily wear and contact.
Materials and warranty
The highest quality materials, installed to manufacturer standards.
We use only the highest quality vinyl materials and window films, following every manufacturer installation step carefully. This means we can confidently achieve the full manufacturer warranty on every job.